Honda ATV Forum banner
1 - 13 of 13 Posts

· Registered
Joined
·
19 Posts
Discussion Starter · #1 ·
I recently purchased a 1995 300ex. i noticed some tape around the wqires coming out of the headlight switch box. When i peeled the tape back it was a mess. All kinds of wires not hooked up and others spliced together. SO i was wondering if any body had the wiring diagram for this because im kind of at a loss. Thanks
 

· Registered
Joined
·
19 Posts
Discussion Starter · #5 ·
Thanks I really appreciate it. I was wondering does it have an actual brake light or just a tail light. And also Any idea why the wire that comes from the smaller of the two computers and goes to the starter switch isnt grounding. If i take this wire and just ground it fires no problem but otherwise nothing. Thanks guys so much for the quick responses
 

· Premium Member
Joined
·
18,211 Posts
the older quads were not equipped with a brake light mine was just a light and it's a 91 most back then were just a light. but yours is a 95 so that's a toss up for me just look for a brake light switch it will be close to the foot brake since you have a clutch.
 

· Premium Member
Joined
·
6,604 Posts
There is a plunger that gets pressed when you step on the brake pedal. It is located directly behind and above the back of your brake lever.(the one by the right peg) If there are wires coming out of that, not hoses, that is what controls the brake light.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top