Honda ATV Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter · #1 ·
I wrecked my 2003 honda 300ex down a hillclimb and bent the axle so here is my question. When I replace the axle do I have to replace the seals and berrings or just the seals or anything at all. your reply will be greatly appreciated Thanks
 

·
Registered
Joined
·
2,735 Posts
Usually you just put the new axle in but if you see that anything is worn replace it while it's a part.
 

·
Super Moderator
Joined
·
18,230 Posts
Agree ^^^ you may have to cut it if it's bent too bad to pull through the carrier.
 

·
Registered
Joined
·
202 Posts
and all depends on how long ago the bearing carryer was repaced if it was me and your that far in to it change it out with a twin roller carryer
 
1 - 4 of 4 Posts
Top