Honda ATV Forum banner
Cancel

300 Fourtrax 2x4 ring pinion gear into 250 Fourtrax 2X4 Dif

8421 Views 26 Replies 4 Participants Last post by  retro, 
8
So I was wondering if it's possible to use a 300 Ring pinion gear in a 250 Fourtrax Rear diff.. I'm going to replace the bearings and seals, but my 250 Fourtrax's rear end sounds way worse .. it only grinds doesn't move at all so I figured there's gonna be more than just replacing some bearings to it.. All i can find on ebay is a 300 Ring pinion gear.. its cheap.. I want to keep it that way .
Reply
Save
Like
1 - 3 of 27 Posts
_Wilson_
Yeah the picture is fuzzy, but i still see some spline damage my 2 pennies ......
Reply
Save
Like
  • Like
Reactions: 1
_Wilson_
Sending you a PM soon :grin , your fixing to get bombed haha!
Reply
Save
Like
  • Like
Reactions: 1
_Wilson_
All those links i sent should be for fourtrax 250 some have part numbers listed and some do not
Reply
Save
Like
1 - 3 of 27 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda ATV Forum
We’re a forum community dedicated to Honda ATV owners & enthusiasts. Come join the discussion about upgrades and reliability for your Rancher, Foreman, Recon, FourTrax, Pioneer, and more!
Full Forum Listing
Explore Our Forums
Repair & Maintenance ATV General Discussion Honda TRX Honda Rancher Honda FourTrax
Top