Honda ATV Forum banner

250ex float ?

2546 Views 8 Replies 4 Participants Last post by  shadetree
i have a 07 250ex. needle valve is sticking, cant seem to get the pin out of the float. any ideas or tools i need.
1 - 2 of 9 Posts
the pin only goes in one way it's knurreled on one end just take like a small nail and drive it out
Yes, I agree with Moose. Be careful not to break the little towers off that hold the pin, they break easy.
If one of the towers that holds the pin in, is taller than the other, the pin comes out the tall tower side. It knocks from the shorter tower out the tall tower side. The short tower is the press fit side.
1 - 2 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.