Honda ATV Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter #1
I have two issues that id live some help on. I have 2106 Rancher with 105 miles with 79 hours on . I think this is why my dash had a wrench with a #1 on it. 2nd, my check engine light is on. This flashes on the right habd side of the dash. Is this the same issues with two warnings?

TIA
 

·
Registered
Joined
·
270 Posts
Count the flashes of the light. It will be a couple of slow flashes followed by a couple of quick ones. Mine did the same thing, it was the o2 sensor at 49 hours. Code 2-3. Using the manual listed here for a 14 rancher you can figure the codes out and how to clear them.
 

·
Registered
Joined
·
53 Posts
Discussion Starter #4
So the oil and filter has been changed. No wrench symbol. The O2 issue, code 23 ( 2 slow flashes, 3 quick ones), had an interesting twist. I started it today and drove it normally after grabbing the sensor wires and the engine light went off.
 

·
Premium Member
Joined
·
5,956 Posts
This is the second for me. I drive very few miles in regard to the hours I have on the machine.
The wrench is the service indicator.... It means it is time for the first oil change.
I would take it out for a cruise occasionally, so that the exhaust system becomes fully hot and is maintained at operating temperature for several minutes. Doing so will help to prevent potential oxygen sensor issues.
 
1 - 6 of 6 Posts
Top