Honda ATV Forum banner

2014 Honda Rancher drive shaft problem

1749 Views 3 Replies 2 Participants Last post by  Veno429
I just got a 2014 Honda Rancher 420 2 wheel drive ES. The rear end was Removed because of shim being bad. I replaced them and put back together. Now the propeller/drive shaft is just spinning on the pinion gear. Looking at them they look fine. What could be my problem. I’ve also removed the spring and set the shaft all the way in and same problem. Lost
1 - 1 of 4 Posts
what shim did you replace ?. any chance you installed the drive shaft backwards ?.. is the output shaft turning when in gear ?. is the pinion gear turning at all ?.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.