Honda ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a Honda 2009 Rancher es, ps I had no difficulty clearing the DTC error codes for the electric shift. However I am unable to reset the error codes on the power steering. Following the service manual instructions for clearing the codes is the same instructions given to initialize the Torque Sensor. With the SCS connector installed the "PS" light continues to blink error codes non stop. Any Ideas?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top