2008 400ex clutch removal tool

3222 Views 11 Replies 5 Participants Last post by XplicitRacing6, Apr 21, 2019

Spooling

Discussion Starter · Apr 17, 2019

Hey guys, just wondering what everyone's using to hold the clutch on their 400ex?

I've been looking online but can't find any obvious tool. I can probably spin it off with an impact gun, but was wanting a proper tool to hold it while torquing it back on.

Thanks

Save

1 - 3 of 12 Posts

shadetree

· #4 · Apr 17, 2019

same, impact off and back on, then stake the nut.

Save

Reactions: 1

shadetree

· #8 · Apr 18, 2019

Spooling said:
OK, so nothing special needed to remove other than an impact gun? Is a new nut needed or can it be reused?

Thanks

going by the book ?, they tell you to use a new nut, me ?, I never buy them !. I always just re-use the old nut. chances of the old nut lining back up to where the old stake in the nut to the indention ?, very slim !!. bottom line : re-use the old nut !.

Save

shadetree

· #9 · Apr 18, 2019

word of caution !!!!. MAKE SURE YOU UNDERSTAND WHICH WAY THE NUT COMES OFF !!!!!!!!. SOME ARE LEFT HAND THREADS ?, OTHERS ARE RIGHT HAND THREADS !!!.

Save

1 - 3 of 12 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month