Honda ATV Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
This 2003 Recon 250 will idle fine but will not stay running after its put into gear. I jacked the old mule up and it will run like that in gear but it seems like the clutch is stuck. This started to get progressively worse all in one day and now it will not run when i put it in gear. It just lunges forward and stalls.
Any ideas?
Gaatvr
 

·
Premium Member
Joined
·
7,533 Posts
Welcome to the forums. It seems there was a question asked a while back about the same thing going on with there ATV. Im sure someone will be along to help shortly.
 

·
Premium Member
Joined
·
23,581 Posts
This 2003 Recon 250 will idle fine but will not stay running after its put into gear. I jacked the old mule up and it will run like that in gear but it seems like the clutch is stuck. This started to get progressively worse all in one day and now it will not run when i put it in gear. It just lunges forward and stalls.
Any ideas?
Gaatvr
Welcome to the forums. That sounds like something is wrong with the centrifugal clutch. I don't know if the one-way clutch bearing will do that or not when they go bad, but if you put one in backwards, that's what they do.
 

·
Premium Member
Joined
·
38,518 Posts
sounds like the centrifulgal clutch..or the clutch disk are bad..or out of adjustment real bad..try adjusting the free play in your clutch disk.
 
1 - 4 of 4 Posts
Top