Honda ATV Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
2003 Rancher, alltime 4 wheel,
I am probably beating a dead horse here, but I am have a problem with the shifting not working at times.
The shifter blinks 3 times. Had problems getting it to reverse. Then sometimes it will work fine , turn it off , then start again, no good.
I call to get a cellenoid, but they said it might be the speed sensor, both costs about $90 . Any ideas? thanks
 

· Premium Member
Joined
·
23,587 Posts
Code 3 is angle sensor or related wiring harness or ECU. I would unplug the connector from the angle sensor and make sure it's good and clean. If it is, follow the procedures below to test the angle sensor system.


 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top