Honda ATV Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
i would like to know what is the proper setting for the air and gas screws on this quad. as in where do i start from 11/2 turns out 2 turns ect.would like to know for all screws and adjust them from a set point after i get it to run . no gas now going to take carb off and clean it.
 

·
Super Moderator
Joined
·
18,227 Posts
Welcome to the forums.

I would turn the pilot screw in until it seats and back it out 3 turns... set the idle and ride it a bit and see how it does. usually its anywhere from 2 1/2 to 3 1/2 turns out from seat
 
1 - 2 of 2 Posts
Top