Honda ATV Forum banner

2000' 400exclutch install probem

1600 Views 6 Replies 5 Participants Last post by  SlammedRanger
Hi, I installed new clutch kit ( springs plates discs) in the basket but now I can barely pull the lever in to get the clutch to disengage. Its as as if there is something bound up. I know I have new springs but this is abnormal. Its just stiff the whole way when pulling. The clutch pac was a standard EBC kit. I tightened the 5 spring bolts in a star pattern and when they bottemed out that was it I didnt continue to keep cranking as I didnt need to snap a 6mm bolt. Any info welcome thanks jim
1 - 1 of 7 Posts
you did soak the friction disc in oil before you put them in didn't you? I agree with slammed ranger the thicker spring in aftermarket kit make the clutces really grab, most of the time better than stock.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top