2000' 400exclutch install probem

1601 Views 6 Replies 5 Participants Last post by SlammedRanger, May 13, 2010

579rdf

Discussion Starter · May 8, 2010

Hi, I installed new clutch kit ( springs plates discs) in the basket but now I can barely pull the lever in to get the clutch to disengage. Its as as if there is something bound up. I know I have new springs but this is abnormal. Its just stiff the whole way when pulling. The clutch pac was a standard EBC kit. I tightened the 5 spring bolts in a star pattern and when they bottemed out that was it I didnt continue to keep cranking as I didnt need to snap a 6mm bolt. Any info welcome thanks jim

Save

1 - 1 of 7 Posts

submarine 300

· #2 · May 10, 2010

Hello and welcome to the forums. It sounds like you might have it installed wrong but without seeing it I can't be sure.

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.