Did you get it figured out? On my 2004 400EX I had that problem and my regulator rectifier had gone bad. On our 2003 300EX I had that problem, and it only happened with the bike was wet after I had washed it, then it went away. Good luck.
2000 400ex wont turn over, just clicks
Pretty sure I've done all this correctly.
Battery- 13ish volts.
13 volts from Neg on battery to hot side of solenoid
13 volts across solenoid terminals when start button is pressed
13 volts from negative on battery to starter when start button is pushed
13 volts from main ground (frame end) to starter when start button is pushed
Nothing happens when solenoid terminals are jumped with key on. No sparks, nada.
Ran jumper cables from both sides of battery on one end to where the ground is connected and and to hot post of starter and nothing happens. No sparks, nada.
Is it the starter??
Thanks
Battery- 13ish volts.
13 volts from Neg on battery to hot side of solenoid
13 volts across solenoid terminals when start button is pressed
13 volts from negative on battery to starter when start button is pushed
13 volts from main ground (frame end) to starter when start button is pushed
Nothing happens when solenoid terminals are jumped with key on. No sparks, nada.
Ran jumper cables from both sides of battery on one end to where the ground is connected and and to hot post of starter and nothing happens. No sparks, nada.
Is it the starter??
Thanks
1 - 1 of 8 Posts
1 - 1 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda ATV Forum
We’re a forum community dedicated to Honda ATV owners & enthusiasts. Come join the discussion about upgrades and reliability for your Rancher, Foreman, Recon, FourTrax, Pioneer, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
