I bib not clean the carb after I had the motor apart. The timing I think is correct. I bib not check the valve clearances. The piston rings looked good.
1999 fourtrax 300 running rugh
hello I recently perches'ed a 1999 honda fourtrax 300 4X4 and it was burning oil so I got a gasket kit and took the engine apart removed the old gaskets and seals and installed the new ones then put it back together and adjusted the timing then I went to start it and I had to give it a bit of throttle for it to start and the it would run really rough. Why? It allways ran vary well and smooth.
1 - 6 of 21 Posts
Piston looks good as well
What are the valve clearances
I'm pretty sure I got the timing wrong so I'm going to work on it today
Well I was right the timing was off so I got it right and it still ran a little rough so I cleaned the carb and now it runs great. Compression cold is 180 psi and hot is 170 psi thanks for your help
1 - 6 of 21 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda ATV Forum
We’re a forum community dedicated to Honda ATV owners & enthusiasts. Come join the discussion about upgrades and reliability for your Rancher, Foreman, Recon, FourTrax, Pioneer, and more!
Full Forum Listing
Explore Our Forums
Top Contributors this Month
View All
oldskool83
32 Replies
Eric the red
16 Replies
THEHONDABUILDER
11 Replies
Recommended Communities
