Honda ATV Forum banner

1996 300cc Honda Fourtrax 4x2

2408 Views 3 Replies 3 Participants Last post by  pintuhs
My bike was running fine until someone stole it a while back.
We quickly recovered the bike, but the punks cut all of my wiring. And cut it REALLY short so I couldn't splice anything back together.

I've replaced all of the cut wiring and fuel lines, but I can't get the motor to turn over.

The green "Neutral" light comes on and I can hear the starter solenoid click, but the starter motor doesn't turn.
I don't have a volt-meter, but using a continuity meter shows power on the starter side of the solenoid (although the meter light is considerably dimmer on the starter side v. the battery side).

The motor cover over the solenoid is removed at this point. I don't think there is any sort of interlock / switch that requires the cover to be installed for the starter to turn. I was thinking I would be able to push the START button and observe the shaft of the starter turn, but that's not happening.

Ok... you guys have any suggestions, or perhaps have any questions for clarification?

Thanks in advance!
1 - 2 of 4 Posts
Charging the battery now. Thought about that right after I posted the question.
Plugged in the charger and it's showing a low level.
I'll let you know how it works out.
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.