Honda ATV Forum banner

1989 TRX 350 tie rod

2546 Views 5 Replies 4 Participants Last post by  ostrx250
Is the left tie rod supposed to be dead straight? Mine has a slight bend to it just outboard of the inner end thread. It may have just been hit and bent but I want to be sure before I straighten it. Can't tell by looking at the schematic.

And while I am at it--I am going to replace the steering stem lower bearing. I have the lower bracket removed from the bike and I am stuck on getting the locknut off. There is a special wrench adapter to fit into the daisey fitment. It is N0. 07GMA-HA70200. Does anyone have a work around tool or am I forced to take it in to the Honda shop for that? Thanks
1 - 1 of 6 Posts
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.