Honda ATV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
On my 89 Fourtrax 300, the plastics are broken and dry rotted. I have noticed that the rear fender is no longer available. So i have an idea to replace the 89 rear fender (80100-HC4-507ZA) with the 1997 TRX300 A rear fenders (80100-HM4-A10ZA). from pictures and the schematic, it looks to me that they are fairly close. My question is will it line up with the seat, and will it bolt to the frame in the right spot. the rack i can make work regardless. Thanks for any help and guidance in this.
 

·
Super Moderator
Joined
·
645 Posts
I think It should bolt right on. But be careful, because if yours is is an '89, it will be a 2x4, and that means no rear mud guards. so lots of little holes in the fender itself. I hope this helps. LOL I am sorry than nobody responded to your post :(
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top