Honda ATV Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I finally got the sending unit out, i hooked it up and moved the float. The gauge appeared to work perfect with light bars from empty to full by moving the float up and down however it was tight and would not move freely.

Since i already cleaned it i decided to take the float arm off to clean and get it moving freely.
Has anyone had one if these apart. I can not figure out how to get it back together.

Please look at the pics to see if i am missing any part that may have fallen out that i didnt notice. Any help with re assembly is much appreciated. Thanks in advance.

Four parts in pic
Sensor
Float arm
Brass fingers
Float rod retainer
Jeff

152494
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top