18% Secondary gear reduction shift problems

2694 Views 3 Replies 3 Participants Last post by Jeepwm69, Feb 5, 2018

Mike.esford

Discussion Starter · Feb 3, 2018

So I've got the gear reduction in and I started slowly shaving the speed sensor down trying to get everything to work. Speedometer started reading but I can't get it to read a gear position. It just has a - or it'll give me a code for the shift angle sensor. Replaced that sensor tried a new shift motor. And I've shaved the speed sensor all the way down to the point of touching the gear. I've got one more speed sensor. Any advice would be greatly appreciated

Save

1 - 2 of 4 Posts

Jeepwm69

· #3 · Feb 5, 2018

When you put the rear cover on, did you get the gear position switch properly aligned with the slot on the back of the shift drum? Sounds like you might have it 180 deg out.

Save

Jeepwm69

· #4 · Feb 5, 2018

http://www.hondaatvforums.net/forums/honda-rancher/58594-420at-shifting-speedometer-issues.html

http://www.hondaatvforums.net/forum...09-475-rancherat-i-ve-been-resto-modding.html

Couple of threads I started when I did mine.

Save

Reactions: 1

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month