Honda ATV Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have an 07 Rancher 420 FM. My sister in law took it out with her friends and now it won't move. It clicks like it's going in gear but you can freely push it around like it's in neutral. Any ideas? Both the drive shaft and diff spin with no resistance.
 

· Premium Member
Joined
·
5,960 Posts
Are you sure the shifter is putting it in gear? What about reverse, tried that gear yet? Make sure the shifter lever is tightened on the shift shaft splines and not slipping. Then pull the boot back covering the rear driveshaft U-joint to verify that those splines haven't stripped off. If it still won't engage you'll probably have to open it up to find whatever might have broken.

Service manuals are linked from here in case you need one:
https://www.hondaatvforums.net/foru...nual-help/50817-service-manual-downloads.html
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top