Honda ATV Forum banner
1 - 18 of 18 Posts

· Registered
Joined
·
1,422 Posts
On the left side of bike were wires push on to gear selector there is a nutral plug reverse plug drive plug on the same harness there is a yellow wire with green stripe I can't find we're it goes it come out of the harness that is showing here
From what I remember on mine that same harness also has the oil temp sensor. And eventually it should end up at the ECM. We'll be able to help and figure this out for you, just not able to get to my service manual at the moment.
 

· Premium Member
Joined
·
38,589 Posts
Same wire comes off of speed sensor or maybe it's called angle sensor it's rite in front of the pic I showed it splits off in back of motor
look too see at bottom back of motor if oil temp wire is still attached to oil temp sensor at lower part of engine at the back end ?.
 

· Premium Member
Joined
·
38,589 Posts
Is # 10 is that a sensor? The list is cut off
yes, # 10 is your oil temp sensor, the sensor is at the very bottom of rear engine cover. is it missing a wire on the sensor ?, if so ?, thats where your extra wire goes :).
 

· Registered
Joined
·
1,422 Posts
You guys are exactly on the right track, I'm not sure about the wire color that was initially mentioned, but if the end of the wire is a bullet connector, and the oil temp sensor has nothing connected to it, then there you go.
 

· Premium Member
Joined
·
38,589 Posts
Yes sir that's it you guys rock thank you all for your time wire was off for long time full of mud couldn't c it
good deal, thanks for the update, and glad ya got it fixed :).
 
1 - 18 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top