[Eman]

Have 05 Honda 250 tried replace cam chain and oil chains..

I have head off and the case cover off...

I have basic knowledge on lining shaft up..but need step by step help how to go about removing clutch and anything else I need to remove to put new chains on this atv

I've been reading this forum for long time..finally breaking down and askin for help..so,e mega smart people on hear..

So any advice on removal..and putting back together process..tools needed etc..any help would be great thanks

 

[shadetree]

welcome to the forums. I have not replaced those chains lately, shoot..not even once !..lol. but I know where they are. you will need to remove the centrifugal clutch, and this calls for a clutch puller tool. I am not sure if the change clutch comes off or not ?. you really should get your hands on the service manual, and it shows you how to go about it, how to line up everything.

 

[Eman]

What are good clutch pulling tools ? And ok...I read a lot of your stuff on hear very smart man.

 

[retro]

You may or may not need clutch pullers depending on how the factory splined those shafts and clutches... Some pull of hard some can pull off by hand. I'm not familiar with your motor and haven't read the FSM section yet either. You may get some clues what is required to get it done from the manual though. Get it HERE if you haven't already.

Have fun, Welcome to the forums!