Honda ATV Forum banner

05 300ex Shift Problem After Repair

4944 Views 2 Replies 2 Participants Last post by  XplicitRacing6
I have a 05 300ex. It was running fine until my 1 way clutch went out. I replaced it and while replacing it it was in neutral. I was pulling the flywheel and heard a click like it was put into gear. It is now stuck in 1st or 2nd gear I believe. It will not shift up or down at all nor will the reverse pull up. It moves a little but will not fully click up or down on the shift selector. I can not find much online about how the shifter mechanism on the drum works. I believe it is the assembly that the reverse attaches to may not be in the correct position may be? Any help would be appreciated! It starts and runs in gear and pulling in the clutch I can start it and ride it but it will not shift at all...
1 - 1 of 3 Posts
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.