Honda ATV Forum banner

03 rubicon foreman code 11

504 Views 2 Replies 3 Participants Last post by  retro
Wheeler stopped shifting after riding in water. I’ve changed the angle sensor and shift control motor and no change. Any ideas?
1 - 1 of 3 Posts
You'll need to clean and dielectric grease every harness connector on the bike. They are not waterproof as shipped from the factory. Wet and corroded connectors may be the only thing wrong with it.

I've attached the DTC info for your bike along with the #11 troubleshooting chart and the resetting procedure you'll need to perform. Check the shift motor by jumping battery voltage across its connectors before you replace it, or the ECM. After cleaning every connector and ground on the bike.... use OEM Honda parts only and let us know how it goes.


See less See more
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.