[LotusCampbell]

Hey y'all I'm 14 and have a beater 250 cc Honda recon, I was just wondering if on the lower steering stem if there is one or two sets of ball bearings? I have knocked out all the balls and need to order a new set and I am not sure if it is one or two sets of bearings.


Sent from my iPhone using Tapatalk

 

[shadetree]

welcome to the forums. the lower steering shaft has only one bearing down at the bottom, and a upper and lower dust seal. you will need a pair of snap ring pliers to remove the snap ring before you hammer the bearing out up, and out of the top of the frame right there.

 

[LotusCampbell]

welcome to the forums. the lower steering shaft has only one bearing down at the bottom, and a upper and lower dust seal. you will need a pair of snap ring pliers to remove the snap ring before you hammer the bearing out up, and out of the top of the frame right there.

No chance your have the part number for this bearing?


Sent from my iPhone using Tapatalk

 

[shadetree]

welcome to the forums. the lower steering shaft has only one bearing down at the bottom, and a upper and lower dust seal. you will need a pair of snap ring pliers to remove the snap ring before you hammer the bearing out up, and out of the top of the frame right there.

No chance your have the part number for this bearing?


Sent from my iPhone using Tapatalk

number 15 on this fich-----> Honda ATV Parts 2002 TRX250TE A STEERING SHAFT Diagram .