Honda ATV Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. Repair & Maintenance
    Just bought a 2003 Honda foreman rubicon with esp ( electric shift program ) from someone who rolled it. The display was broken and he told me that the esp doesn't work until I got a new display was just wondering if anyone could verify before I drop 300$.also Has trouble going over 20-25 miles...
  2. Repair & Maintenance
    hi, my father-in-law drove his atv over the other day and it won't start back up. The solenoid would just make the click noise. The battery was the original when he bought new in 2012. I took it to a battery shop and they load tested it and said it was bad. I bought a new one and installed but...
  3. Repair & Maintenance
    I have a 2006 Foreman 500 4x4 and the front output shaft seal was leaking and finally got around to fixing it. A buddy came over and helped since he said he had experience with these seals. Well got the front diff moved and shaft disconnected. Got the old seal out and he cleaned the shaft up...
  4. Visual & Body Modifications
    I have 2006 model of Honda Foreman 500, with wider tires so I have been getting mud and dirt all over in such conditions. Has someone here put on its ATV extra wide fenders / fender flares / over fenders and some knowlegde to share :) ? Greetings from Iceland Elvar Lund
  5. New Member Introductions
    Like the title says, I have a 2013 Foreman 500FM. I'm trying to install a brand new (2022) Warn VRX25 winch, and am pretty close to losing my mind. After most of a day, and removing several more bolts than the instructions called for, I finally got the first 2 bolts through the mounting plate...
  6. Repair & Maintenance
    Hey this is my first time on a forum asking a question but I just bought a 2013 foreman 500 Manuel shift 4x4 and it runs great no smoke no other noise but when it’s at operating temp it has a not consistent ping/tick and goes away with any amount of throttle barely rest your thumb on the...
  7. Repair & Maintenance
    2004 rubicon 500. (Trx500fa) It will cold start and run PERFECT. I mean no smoke, no tics, idles absolutely beautiful. Rev it up perfectly. But after a few minutes it will start to sputter out and die. Trying to give it fuel makes it worse. If it does recover it’s fine again. But usually it dies...
  8. Honda TRX
    Okay so I got an issue with the foreman I just rebuild top and bottom end. It is the ES model so I do have electronic display of my gears. I have a neutral light and a display for first gear. Every other gear the bike shifts into fine BUT there is no display of the gear number nor dash’s. I can...
  9. Repair & Maintenance
    Good day y'all, So went ahead and crashed a perfectly good 2006 honda foreman 500 s. Aside from myself, I also managed to fubar the front end and frame. Looking around I see some older foremans for sale and wondering if the frame is the same size? One particular one I'm looking at is a 99...
  10. Repair & Maintenance
    Hi all. I have a 2006 rubicon ES, for some reason it will not shift, it’s blinking an error code for incorrect angle sensor voltage, however I have replaced the angle sensor and shift motor. Any help/suggestions?
  11. Builds, Projects & DIY
    Hello all, I recently picked up a 2003 honda foreman rubicon 500. Absolutely beautiful machine. I have one major issue though. When I picked up the machine it ran beautifully idled great and had good response when I cracked the throttle. The next day I went to take it for a rip and every time I...
  12. Repair & Maintenance
    I took my 06 500 foreman for a ride last winter, i had just fixed a smoking issue from dirty filter. Started perfect, ran good for 10 min, headed to the Bush and I noticed I was loosing power so I gave it more throttle and it eventually quit running. After a few min of trying to get it running I...
1-12 of 12 Results
Top