Honda ATV Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 43 Results
  1. Honda FourTrax
    Hi all. I'm looking to buy a new carb to replace my oe cracked one. But the only time I see a direct fit on Amazon the cap is a bowl and not flat like the oe.. when I find one that identical in every way the description says its for big red 250. This is the same carb is it not? And if so will...
  2. ATV General Discussion
    Hi all! Thanks for taking a look in advance. I got a killer deal, and it is a carburetor fuel system. Unfortunately my experiences with a carburetor fuel system are lacking. Last time I had one was in the late 90s lol. So here is my question: The machine starts right up when using the low...
  3. Repair & Maintenance
    I have a 400ex that's backfiring on deceleration. Initially i thought it might be running lean but then I noticed it blowing a bit of black smoke on full throttle. This made me think it's rich. The backfiring isn't very bad but its definitely noticable. I also noticed it bogging a little in...
  4. Repair & Maintenance
    This is one of those things that's so simple that people tend to gloss over it. Even D-Ray's videos only spend all of about 3-5 seconds as if it's just a given - so I'm posting my guide here. My experience is with a 1988 FourTrax 300 4x4 and 2000 FourTrax 400 2x4, but I imagine most Hondas are...
  5. ATV General Discussion
    Hello i have a few questions about the Vacuum/Carb Hoses for my Honda Rancher. Q1 : Does this hose have any connection or will it hang there ? Q2 : Does this Hose connect to the bottom of the carburetor ? Q3 : Will it be left hanging after connecting it to the carburetor or will it...
  6. Honda Rancher
    Just got my first quad. Here is some details so far. It sat in a barn 10 years! 05 Honda rancher trx400fa Changed oil New batt New air filter Cleaned carb w/wire and cleaner Flushed gas tank New fuel shut off valve/filter New spark plug Had ethenol fuel, changed to non eth. 92 Oct When I got...
  7. Repair & Maintenance
    I have been working on this Atc 200s and it just won't keep running right. I've completely went through the carb piece by piece and cleaned them, ran some gas through the tank to make sure nothing was in it, and messed with adjustments and throttle. When I run the machine, it runs great for a...
  8. Performance Modifications
    Hi, I recently did a pretty big build last weekend. We did a 440 kit with 10.5-1 compression, stage 3 hot cams, slight porting, full yoshimura exhaust, and no air box lid. Only trouble I’ve ran into so far is the jets. I just bought a 180/185 main and 42 pilot. The carburetor is stock. Should...
  9. Repair & Maintenance
    Hey y’all, so I went riding this last weekend and halfway threw the riding all day I started only getting 1/4 to 1/2 throttle and if I went full throttle it’d start bogging and spitting, (idk how I made it up those muddy hills😅) but anyways so I took apart the carburetor started cleaning it...
  10. Repair & Maintenance
    I have taken the carb off twice to clean all the jets and blow it all out with carb cleaner and compressed air. I drained and flushed the fuel tank and line. I have replaced the plug and air filter. Since I discovered a huge nest in the air box, I also did a compression test and it was 180. It...
  11. Performance Modifications
    hey guys looking for a carburetor for my 400ex and I my two opinions are a 04-05 Trx450r carb or a lectron and I was wondering what carb would have a better throttle response? I know the lectron doesn’t have a accelerator pump so I didn’t know how the throttle response would be. Thanks for the help
  12. Builds, Projects & DIY
    I have a 185(s) engine. No frame or anything. Got it from my farm after my grandfather passed. I have a box of parts from a 185(s) it connsists of a chain, muffler, rubber washers, bolts to mount it, other random parts I cannot identify. The engine has no electrical stuff other than a 3 prong...
  13. Repair & Maintenance
    ‘00 TRX400EX cannot figure out what the carb’s issue is. Cleaned thoroughly, tried moving jet needle position, adjusting pilot, etc... Upon starting, take off is rough. Cutting in and out, until second gear; then it’s actually able to get gas~then in third, it’s fine. Smooth and not temperamental🙄
  14. Repair & Maintenance
    New account here. Got an 02 Honda rancher that has carburetor problems and need some help. I rebuilt the carb with a new kit jets, gasket and needle. When I put the carb on the bike by itself and turn on the gas the bike will crank up fine. So I continue to reassemble the carb and screw in the...
  15. Honda TRX
    I have a 2000 trx400ex; the carb needle seems to need adjusting but, there’s only one position on the needle sooo.. any thoughts/suggestions? Bogging down, coming downhill and while level but, not going uphill. Help 😭 please and thank you.
  16. Repair & Maintenance
    1999 Honda 300 FOURTRAX. Carb was replaced (supposedly) before I bought it last year. Runs great. Just doesn’t have great idling. Also fuel in air box anytime it sits for too long (with fuel on) or is ridden too hard. Any suggestions?
  17. ATV General Discussion
    What after market carburetor will work best for my 1985 Honda Fourtrax 250?
  18. Builds, Projects & DIY
    Hey guys, I recently bought a Chinese carb for my 1984 atc200s as the float was fecked in my OEM one. So after installing the new PZ27 carb it started leaking from the bottom nipple. So I replaced the jets with the OEM ones but it still leaked. So once again I took it off and this time I thought...
  19. Honda FourTrax
    Hi all. Newbie here to the forum and ATVs in general. I just picked up a 86 TRX350 barn-find that last ran 6 years ago or there about. Replaced the battery, cleaned/re-gapped the plug and drained the old gas for new. She fired up almost immediately. The mechanics appear to be sound but the...
1-20 of 43 Results
Top