I'm finding it very difficult to find a suitable place to mount the DNR rear plate that is req'd here in Wisconsin. The tailgate does not have a flat spot large enough (some older models did), and the tilt bed eliminates the area just below that bed. I was told of some melting of the heat shield on the muffler if the plate was mounted there.
What is left except on the contoured tail gate where the plate is destined to get bent up?
I'm finding this simple task to be a little perplexing. Ideas????? Thanks
Could you post some pics of the tailgate and plate?
2004 TRX400FA (Rancher 400AT)
MotionPro twist throttle kit
12" handlebar mounted light bar
rear rack wheelchair carrier
Cycle Country 48" plow w/ KFI hybrid mount
Champion 3000 lb winch w/ synthetic rope
23" Titan 489's all around (saving clutch)
2011 Grizzly 450 EPS
Others in the family: '04 TRX250TE, '85 TRX250 Utility (X2), '05 TRX90, '06 TRX500FA, '95 TRX400FW,' 88 TRX125