Hey Kentco, thanks for getting back with me. I thought the same thing. I took my gas tank and rear plastic off yesterday and by dark I was completely bummed!! Then I went back after it today and was gonna check every last part. As I was taking off the bottom skid plate off, I noticed on the back, bottom of the crank case there was plug , or switch. It looked like the same kind of plug on the bottom left side of the quad that is labeled D,N,R and were connected to the one I found. After looking, the plug I found, it's wire was kinked…like 90 degree kinked. So I doctored it up, plugged it back in and voila!! My gear indicator display was functioning normal and I could hear the control motor kick on when I moved the gear shift. It started right up and sounded fine. But it got dark on me and I had to quit. I'm gonna get back on it tomorrow and start the initial setup process. I'll get back to u tomorrow night and let u know the out come. Keep your fingers crossed. Thanks again