FI Light Reset - Honda ATV Forum
Honda Rincon Discussions for the Honda Rincon 650 and Honda Rincon 680.

LinkBack Thread Tools Display Modes
post #1 of 4 (permalink) Old 07-11-2011, 02:38 PM Thread Starter
Junior Member
BuckT's Avatar
Join Date: Jul 2011
Posts: 2
FI Light Reset

Hi I have a 2007 Rincon with the FI light flashing. It flashes 9 time and starts flashing again. Would anyone know what that code means and how to reset the light so it doesn't flash. It just started on the weekend while I was driving. The engines still runs good.
I also have a problem with my transmission. Sometimes it shifts properly and sometimes it shift at high RPM for no reason.

Thanks in advance for your help
BuckT is offline  
Sponsored Links
post #2 of 4 (permalink) Old 07-11-2011, 05:05 PM
Super Moderator
Supporting Member
Deeperinthabush's Avatar
Join Date: Feb 2011
Location: No longer in Pensacola Fl.
Posts: 11,311
Liked: 54 times
Welcome to the forums...Did you check out the shifting troubleshooting section,or the code reading section in the free manual you downloaded???

FREE REPAIR MANUALS >> 1986-1992 trx350 parts for sale>>
Deeperinthabush is offline  
post #3 of 4 (permalink) Old 07-12-2011, 05:08 AM
Senior Member
unclejpl4x4's Avatar
Join Date: Jul 2010
Location: Southern Jersey
Posts: 233
I don't know what the codes are but i would give the plugs on the tranny a wiggle test and while U have them unpluged check them for corrosion/ water and use some die-electric grease be for pluging them back in.

04 honda rincon: RDC 2" lift,1" wheelspacer, HL springs, warn bumper/winch, k&N carb kit, Custom hitch, custom exhaust snorkel, rear cargo box, 26" GBC Grim Reapers, Gorilla rad kit.
unclejpl4x4 is offline  
Sponsored Links
post #4 of 4 (permalink) Old 07-12-2011, 08:08 AM Thread Starter
Junior Member
BuckT's Avatar
Join Date: Jul 2011
Posts: 2

Thanks for the response.
I did check the code in the manual that I downloaded from this site and, I think that it's the IAT Sensor. I will be inspecting today.
For the shifting of the transmission it doesn't give me a code. I will check the connections and coat the connectors with die-electric grease. I have installed a Big red gear kit a few weeks ago and seam that the transmission been shifting eratic since then. My boys have been using it more than I did since I installed the gear kit. I look in the manual to see if I can adjust the shifting range speed and I didn't find any adjustment.
To reset the light I don't understand the procedure in the book without the pocket tester.
Would any one know how to reset the light before I short the wrong wires and fry my computer?
BuckT is offline  

  Lower Navigation
Go Back   Honda ATV Forum > Honda Model Specific Discussions > Honda Rincon

Quick Reply

Register Now

In order to be able to post messages on the Honda ATV Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome